CONTEGA SOLIDO EXO
Installation steps: Window already installed
1. Window in masonry structure
CONTEGA SOLIDO EXO is to be applied subsequently to an already mounted window.
1. Window in masonry structure
CONTEGA SOLIDO EXO is to be applied subsequently to an already mounted window.
2. Create a sub-sill
First create a sub-sill as a second waterproof layer using the EXTOSEAL ENCORS sealing adhesive tape. Guide the tape into the corners precisely and also run it to a height of 20 cm (8") on the reveals on each side.
2. Create a sub-sill
First create a sub-sill as a second waterproof layer using the EXTOSEAL ENCORS sealing adhesive tape. Guide the tape into the corners precisely and also run it to a height of 20 cm (8") on the reveals on each side.
3. Cut the CONTEGA SOLIDO EXO window-sealing tape
Add approx. 4 cm (1 5/8") to the height of the frame and cut this length of tape.
3. Cut the CONTEGA SOLIDO EXO window-sealing tape
Add approx. 4 cm (1 5/8") to the height of the frame and cut this length of tape.
4. Stick to the frame
Remove the narrow release film strip. Apply the CONTEGA SOLIDO EXO to the corner of the frame along the full width of the adhesive strip, allowing for an excess of 2 cm (3/4"). Stick the excess tape to the adjacent reveal surfaces.
4. Stick to the frame
Remove the narrow release film strip. Apply the CONTEGA SOLIDO EXO to the corner of the frame along the full width of the adhesive strip, allowing for an excess of 2 cm (3/4"). Stick the excess tape to the adjacent reveal surfaces.
7. Stick the corners and all around the window
Continue sticking the rest of the window (window frame and reveals) in the same manner. Ensure that the corners are taped over.
7. Stick the corners and all around the window
Continue sticking the rest of the window (window frame and reveals) in the same manner. Ensure that the corners are taped over.